Sometimes there is screws that hold this lower steering column cover on, but this vehicle doesn't have screws, so just grab it, pull it straight down just like that. Now I'm going to grab this panel and pull it down. If you have, just try to get a little screwdriver and pry it out, but you really got to force it out. Next, I'm going to grab this handle for this steering wheel adjustment and I'm just going to pull it straight outwards just like that. There's clips on the back side right here, right here, and right here. Now I'm just going to grab this panel and pull it straight forward. Just a Phillips head screw, take that out. There's also one over here, this vehicle that's missing. Then, I'm going to take this release handle and slide it towards the front of the vehicle and then slip it out. We're going to remove a bolt that's underneath this parking brake release lever right here. Next, I'm going to take out a 10mm socket, extension, and a ratchet. Just grab under here with your hand, pull up, slides right out. We're going to remove this cover right here. Loosen this up, wiggle it back and forth and set it aside. You can probably do it without taking that bracket off, but just make it easier to take the bracket off. I'm just going to use a 10mm wrench, loosen up the cable. You would take those out to access the negative battery cable. Normally, there would be a bracket here with four 13mm bolts. This vehicle, there is a bracket missing here. If you need this part or other parts for your vehicle, click the link in the description and head over to. Here, I'm going to be replacing an ignition switch in this 2008 Chevy Silverado work truck. We've been selling auto parts for over 30 years. Push the two tabs to release the ignition switch.Reinstall the lock cylinder and turn it to the accessory position.Disconnect the ignition electrical conenctor.Remove the anti-theft control module by prying a tab at the rear.Disconnect the anti-theft control module electrical connector. Use a pick to push into the lock cylinder release hole, and remove the lock cylinder.Insert the key into the lock cylinder and turn and hold it in the start position.Remove the lower and upper steering column covers.Remove the screws securing the lower steering column cover if necessary.Remove the steering wheel adjustment handle.Remove the lower driver side dash panel.Remove the two Phillips screws securing the lower driver side dash panel.Remove the 10 mm bolt behind the parking brake release level to remove it.Disconnect the negative battery cable by loosening the 10 mm nut.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |